Jersey barrier

From Wikipedia, the free encyclopedia.

Jump to: navigation, search

A Jersey barrier was originally developed to divide multiple lanes on a highway by the state of New Jersey in the United States. A Jersey barrier stands 3–5 feet tall and is made of poured concrete. Their widespread use on the highway has led to many other uses as a general barrier. They are also known as K-rails (especially when used temporarily during roadway construction) or traffic dividers.

A Jersey barrier is a concrete barrier originally developed as a highway median.
Enlarge
A Jersey barrier is a concrete barrier originally developed as a highway median.

The design of the Jersey barrier was specifically intended to minimize damage and reduce the likelihood of a car crossing into oncoming lanes in the event of a collision. For the more common shallow-angle hits, the Jersey barrier is intended to minimize sheet metal damage by allowing the vehicle tires to ride up on the lower sloped face.

For higher impact angles, the Jersey barrier is actually a multistage barrier. The front bumper impacts the upper sloped face and slides upwards. This interaction initiates lifting of the vehicle. If the bumper is relatively weak, the front end starts to crush before any uplift occurs. Then, as the vehicle becomes more nearly parallel with the barrier, the wheel contacts the lower sloped face. Most of the additional lift of the vehicle is caused by the lower sloped face compressing the front suspension. However, wheel side-scrubbing forces provide some additional lift, particularly if the barrier face is rough. Therefore, exposed aggregate and other rough surface finishes should be avoided. Modern vehicles have relatively short distances between the bumper and the wheel; as a result, bumper contact is followed almost immediately by wheel contact.

It is only necessary to lift the vehicle enough to reduce the friction between the tires and the paved surface. This aids in banking and redirecting the vehicle. If the vehicle is lifted too high into the air, it may yaw, pitch, or roll, which can cause the vehicle to roll over when the wheels come in contact with the ground again. Preferably, concrete safety shape barriers should be adjacent to a paved surface so that the wheels cannot dig into the soil and cause the vehicle to overturn.

Modern variations include the Constant Slope Barrier, which has one constant slope from the base to the top, and the F-Shape Barrier. The F-Shape is similar to the Jersey Barrier in appearance, but has different angles and is much taller. The F-Shape is thought to be the best current concrete barrier design. It takes its name from a set of tested barriers that were assigned letters as identification.

In the State of New Jersey the term "Jersey barrier" is rarely utilized. Residents, government agencies, and road traffic and media reports on radio and television (including stations located in New York City and Philadelphia) usually use the term "traffic divider".

The older barrier system of guard rails or guide rails did not prevent traffic from entering on-coming traffic. New Jersey first used concrete traffic barriers in 1955; the current accustomed shape was first implemented in 1959 as a result not of crash testing, but of police observation of the accident results of previously installed concrete barriers.

See also

References

External links

Personal tools